RDX L4-2.3L Turbo (2008)
Starter Motor: Removal and Replacement
Starter Removal and Installation
Removal
1. Make sure you have the anti-theft code for the audio system and the navigation system (if equipped). Make sure the ignition switch OFF.
2. Disconnect the negative cable from the battery.
3. Remove the clip (A), then remove the coolant reservoir (B) from the holder.
4. Remove the clips (A), then remove the support rod clamp bracket (B).
5. Disconnect the A/C condenser fan motor connector (A), then remove the A/C condenser fan shroud assembly (B).
6. Remove the harness clamp (A) and connector (B), then remove the intake manifold bracket (C).
