RDX L4-2.3L Turbo (2008)
8. Remove the self-locking nuts (A), and separate the knuckle from the trailing arm (B).
NOTE: During installation, install new self-locking nuts.
9. Position a floor jack under lower arm B.
10. Remove the flange bolt (A), then remove the knuckle (C).
NOTE: During installation, install a new flange bolt.
11. Install the knuckle in the reverse order of removal, and note these items:
^
First install all the components, and lightly tighten the bolts and nuts, then raise the suspension to load it with the vehicle's weight before fully
tightening to the specified torque values.
^
Be careful not to damage the ball joint boot when installing the knuckle.
^
Before connecting the lower ball joint to the knuckle, degrease the threaded section and tapered portion of the ball joint pin, the knuckle
connecting hole, the threaded section, and mating surface of the castle nut.
