RDX L4-2.3L Turbo (2008)
7. Remove the brake disc.
8. Check the front hub for damage and cracks.
9. Remove the cotter pin (A) from the tie-rod end ball joint, then remove the nut (B).
NOTE: During installation, install a new cotter pin after tightening the nut, and bend its ends as shown.
10. Disconnect the tie-rod ball joint from the knuckle using the ball joint remover.
11. Remove the lock pin (A) from the lower ball joint (B) then remove the castle nut (C).
NOTE: During installation, install a new lock pin after tightening the new castle nut.
12. Disconnect the lower ball joint from the knuckle.
13. Remove the damper pinch bolts (A) and the self-locking nuts (B) from the damper.
