RDX L4-2.3L Turbo (2008)
Wheel Bearing: Testing and Inspection
Wheel Bearing End Play Inspection
1. Raise the vehicle, and support it with safety stands in the proper locations.
2. Remove the wheels.
3. Install suitable flat washers (A) and the wheel nuts. Tighten the nuts to the specified torque to hold the brake disc or disc/drum securely against the
hub.
4. Attach the dial gauge. Place the dial gauge against the hub flange.
5. Measure the bearing end play by moving the disc or disc/drum inward and outward.
Front/Rear: Standard: 0-0.05 mm (0-0.002 inch)
6. If the bearing end play measurement is more than the standard, replace the wheel bearing or hub bearing unit.
