RDX L4-2.3L Turbo (2008)
Pressure Regulating Solenoid: Service and Repair
A/T Clutch Pressure Control Solenoid Valve A and B Replacement
A/T Clutch Pressure Control Solenoid Valve A and B Replacement
1. Make sure you have the anti-theft codes for the audio system and the navigation system (if equipped).
2. Disconnect the negative cable from the battery, then disconnect the positive cable.
3. Remove the battery hold-down bracket, and remove the battery cover, the battery, and the battery tray.
4. Remove the battery base.
5. Remove the intercooler cover, the air cleaner housing, and the intake air duct.
6. Remove the nuts securing the shift cable bracket (A).
7. Remove the spring clip/washer (B) and control pin (C), then separate the shift cable end (D) from the control lever (E).
8. Check the bushing (F) in the shift cable end for proper fit and wear. If the bushing is loose or worn, replace the shift cable.
9. Disconnect the input shaft (mainshaft) speed sensor connector (A), the output shaft (countershaft) speed sensor connector (B), the 3rd clutch
transmission fluid pressure switch connector (C), and the ATF temperature sensor connector (D).
10. Disconnect the A/T clutch pressure control solenoid valve A connector (A), the solenoid valve B connector (B), and the shift solenoid harness
connector (C).
