RDX L4-2.3L Turbo (2008)
17. Remove the bolt securing the harness cover (D).
18. Remove A/T clutch pressure control solenoid valves A and B, ATF pipes (C), gasket (D), and O-rings (E).
19. Check the fluid passage of the solenoid valve for contamination.
20. Connect a jumper wire from the negative battery terminal to clutch pressure control solenoid valve B connector terminal No. 2, and connect
another jumper wire from the positive battery terminal to connector terminal No. 1. Make sure A/T clutch pressure control solenoid valve B
moves.
21. Disconnect one of the jumper wires, and check valve movement at the fluid passage in valve body mounting surface. If the valve binds or moves
sluggishly, or if the solenoid valve does not operate, replace the A/T clutch pressure control solenoid valves A and B.
22. Clean the mounting surface and fluid passage of the solenoid valve body and solenoid valve cover.
23. Install the new solenoid valve body gasket on the solenoid valve cover, and install the ATF pipes with the filter end in the transmission housing.
Install the new O-rings over the ATF pipes.
24. Install the A/T clutch pressure control solenoid valves A and B.
25. Secure the harness cover with the bolt.