RDX L4-2.3L Turbo (2008)
12. Remove the spring clip/washer (B) and control pin (C), then separate the shift cable end (D) from the control lever (E).
13. Remove the heat shield from under the body.
14. Remove the nuts securing the shift cable bracket.
15. Remove the nut securing the shift cable bracket (A).
16. Remove the shift cable grommet (B), and pull out the shift cable (C).
17. Insert the new shift cable through the grommet hole (D), and install the grommet in its hole. Do not bend the shift cable excessively.
18. Make sure that the transmission is in Rat the transmission control lever.
19. Apply molybdenum grease to the hole in the bushing (A) in the shift cable end (B). Attach the shift cable end to the control lever (C), then insert
the control pin (D) into the control lever hole through the shift cable end, and secure the control pin with the spring clip/washer (E).