RDX L4-2.3L Turbo (2008)
23. Remove the mounting bolts, then remove the solenoid valves.
24. Install new O-rings (two O-rings per solenoid valve) (E) on the reused solenoid valves.
NOTE: A new solenoid valve comes with new O-rings. If you install a new solenoid valve, use the O-rings provided with it.
25. Install shift solenoid valve D (black connector) by holding the shift solenoid valve body; make sure the mounting bracket contacts the accumulator
body.
NOTE: Do not hold the solenoid valve by the connector when installing the solenoid valve. Be sure to hold the solenoid valve body.
26. Install shift solenoid valve A (black connector) by holding the shift solenoid valve body; make sure the mounting bracket contacts the accumulator
body.
27. Install shift solenoid valve C (brown connector) by holding the shift solenoid valve body; make sure the mounting bracket contacts the bracket of
shift solenoid valve A.
NOTE: Do not install shift solenoid valve C before installing shift solenoid valve A. If shift solenoid valve C is installed before installing shift
solenoid valve A, it may damage the hydraulic control system.
28. Install shift solenoid valve B (brown connector) by holding the shift solenoid valve body; make sure the mounting bracket contacts the
accumulator body.
29. Connect the harness terminals to the solenoid:
^
GRN wire connector to shift solenoid C.
^
YEL wire connector to shift solenoid A.
^
RED wire connector to shift solenoid B.
^
ORN wire connector to shift solenoid D.
30. Install the shift solenoid valve cover, dowel pins, and a new gasket.
