RDX L4-2.3L Turbo (2008)
12. Install the new gasket (A) on the transmission housing, and install the 8 x 34.5 mm ATF joint pipe (B) with the filter end into the transmission
housing and 8 x 25.2 mm ATF pipe (D).
13. Install the new O-rings (E) over the ATF joint pipes.
14. Install A/T clutch pressure control solenoid valve C.
15. Check the connector for rust, dirt, or oil, then connect the connector securely.
16. Install the intake air duct, the air cleaner housing, and the intercooler cover.
17. Install the battery base.
18. Install the battery tray, the battery, the battery cover, and the battery hold-down bracket, then reconnect the battery cables.
19. Enter the anti-theft codes for the audio system and the navigation system (if equipped). Set the clock (on vehicle without navigation).
20. Do the power window control unit reset procedure.