RDX L4-2.3L Turbo (2008)
17. Remove the solenoid valve cover (A), dowel pins (B), and gasket (C).
18. Replace the gasket with a new one when installing the solenoid cover.
19. Disconnect the connectors from shift solenoid valve A, shift solenoid valve B, shift solenoid valve C, and shift solenoid valve D.
20. Measure the resistance of each shift solenoid valve between the connector terminal and body ground.
Standard: 12-25 Ohms
^
If the resistance is out of standard, go to step 23 and replace shift solenoid valve.
^
If the resistance is within the standard, go to step 21 and check the solenoid valve for a clicking sound.
21. Connect a jumper wire from the positive battery terminal to each solenoid valve terminal individually.
^
If a clicking sound is heard, go to step 22 and replace the shift solenoid harness.
^
If no clicking sound is heard, go to step 23 and replace shift solenoid valve.
22. Remove the shift solenoid wire harness connector (A), and replace it. Install a new O-ring (B) on the shift solenoid harness connector, and install
the connector in the transmission housing, then go to step 29.
