RDX AWD L4-2.3L Turbo (2010)
Keyless Entry: Component Tests and General Diagnostics
Door Lock Knob Switch Test
Door Lock Knob Switch Test
Driver's Door
1. Remove the driver's door panel See: Body and Frame/Doors, Hood and Trunk/Doors/Front Door/Front Door Panel/Service and Repair/Front
Door Panel Removal/Installation.
2. Disconnect the 10P connector (A) from the actuator (B).
3. Check for continuity between the terminals.
-
There should be continuity between terminals No. 6 and No. 5 when the door lock knob switch is in the LOCK position and no continuity
when the switch is in the UNLOCK position.
-
There should be continuity between terminals No. 7 and No. 5 when the door lock knob switch is in the UNLOCK position and no continuity
when the switch is in the LOCK position.
4. If the continuity is not as specified, replace the door latch See: Body and Frame/Doors, Hood and Trunk/Doors/Front Door/Front Door
Latch/Service and Repair.
Passenger's Door
1. Remove the passenger's door panel:
-
Front passenger's door panel See: Body and Frame/Doors, Hood and Trunk/Doors/Front Door/Front Door Panel/Service and Repair/Front
Door Panel Removal/Installation
-
Rear door panel See: Body and Frame/Doors, Hood and Trunk/Doors/Rear Door/Rear Door Panel/Service and Repair/Rear Door Panel
Removal/Installation
2. Disconnect the 10P connector (A) from the actuator (B).
