RDX AWD L4-2.3L Turbo (2010)
Integrated Accessory Switch Assembly: Service and Repair
Dashboard Driver's Switch Panel Removal/Installation
Special Tools Required
-
KTC Trim Tool Set SOJATP2014
*Available through the Acura Tool and Equipment Program; 888-424-6857
NOTE:
-
Put on gloves to protect your hands.
-
Use the appropriate tool from the KTC trim tool set to avoid damage when removing components.
-
Take care not to scratch the dashboard or the related parts.
1. Remove the driver's switch panel (A).
1. Pull out the bottom of the panel to detach the clips, and pull it down to release the hooks (B).
2. Disconnect the power mirror switch connector (C) and the VSA OFF switch connector (D).
2. Install the panel in the reverse order of removal, and note these items:
-
If the clips are damaged or stress-whitened, replace them with new ones.
-
Push the clips and the hooks into place securely.
-
Make sure each connector is plugged in properly.
