RDX AWD L4-2.3L Turbo (2010)
Navigation Module: Service and Repair
Navigation Unit Removal/Installation
SRS components are located in this area. Review the SRS component locations See: Restraint Systems/Air Bag Systems/Locations, and the precautions
and procedures See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Air Bag(s) Arming and Disarming/Service and Repair in
the SRS section before doing repairs or service.
NOTE:
-
Before replace the navigation unit, back-up the client data using system diagnostic mode save users memory under the functional set up See:
Testing and Inspection/Initial Inspection and Diagnostic Overview/Navigation System Diagnostic Mode.
-
If the navigation unit is replaced or disconnected, a Map Matching must be done See: Testing and Inspection/Initial Inspection and Diagnostic
Overview/How to Troubleshoot the Navigation System.
1. Turn the ignition switch to ON (II).
2. Eject the navigation DVD from the original navigation unit See: Service and Repair. To avoid scratching or damaging the DVD, temporarily
place the DVD in a jewel case.
NOTE: If the DVD does not eject, refer to symptom troubleshooting Navigation unit does not eject or accept the navigation DVD.
3. Turn the ignition switch to LOCK (0).
4. Remove the passenger's console cover See: Body and Frame/Interior Moulding / Trim/Console/Service and Repair/Removal and
Replacement/Center Console Removal/Installation.
5. Remove the nuts (A), then pull out the navigation unit (B).
6. Disconnect the connectors (C), then remove the bolts (D) and the brackets (E).
7. Install in the reverse order of removal.
8. Turn the ignition switch to ON (II), then reinstall the client's original navigation DVD, verifying that the DVD is free of scratches or smudges.
9. Check any official Honda service web site for more service information about for the navigation system. Apply any prescribed patches to the new
navigation unit.