RDX AWD L4-2.3L Turbo (2010)
Rear Door Exterior Handle: Service and Repair
Rear Door Outer Handle Replacement
NOTE:
-
Put on gloves to protect your hands.
-
Take care not to scratch the door or the related parts.
1. Raise the glass fully.
2. Remove the door panel See: Rear Door Panel/Service and Repair/Rear Door Panel Removal/Installation.
3. Detach the harness clip (A), and disconnect the power door lock actuator connector (B). Remove the plug caps (C), then remove the plastic cover
(D), as needed.
4. Remove the screws and the nut securing the latch See: Rear Door Latch/Service and Repair.
5. Detach the latch cable (A) and the inner handle cable (B) from the holder (C), and lower the latch (D). Take care not to bend the latch cable, and
the inner handle cable.
6. Detach the rod fastener (A).