RDX AWD L4-2.3L Turbo (2010)
Fuel Door Release Cable: Service and Repair
Fuel Fill Door Opener Cable Replacement
SRS components are located in this area. Review the SRS component locations See: Restraint Systems/Air Bag Systems/Locations and the precautions
and procedures See: Interior Moulding / Trim/Dashboard / Instrument Panel/Air Bag(s) Arming and Disarming/Service and Repair before doing repairs
or service.
NOTE:
-
Put on gloves to protect your hands.
-
Take care not to scratch the body or related parts.
1. Remove these items:
-
Rear seat cushion See: Seats/Service and Repair/Rear Seat Removal/Installation
-
Rear seat side bolster, left side See: Seats/Service and Repair/Rear Seat Removal/Installation
-
Front door sill trim, driver's side See: Interior Moulding / Trim/Scuff Plate/Service and Repair
-
Kick panels, driver's side See: Interior Moulding / Trim/Scuff Plate/Service and Repair
-
Rear door sill trim, left side See: Interior Moulding / Trim/Scuff Plate/Service and Repair
-
B-pillar lower trim, left side See: Interior Moulding / Trim/Trim Panel/Service and Repair/Pillar Trim/Interior Trim Removal/Installation -
Pillar Areas
-
Cargo area side trim panel, left side See: Interior Moulding / Trim/Trim Panel/Service and Repair/Interior Trim Removal/Installation - Rear
Side Area
-
Fuel fill door opener See: Fuel Door Release Lever/Service and Repair
2. Pull the carpet back as needed.
3. Release the opener cable (A) from the clip (B) and the hooks (C) of the wire harness bands. Remove the wire harness band (D) and the cushion
tape (E).
4. Pinch the hooks (A) from inside the vehicle, remove the grommet (B) from the body.