RDX AWD L4-2.3L Turbo (2010)
Passenger Assist Handle: Service and Repair
Grab Handle Removal/Installation
Special Tools Required
-
KTC Trim Tool Set SOJATP2014
*Available through the Acura Tool and Equipment Program; 888-424-6857
NOTE: Use the appropriate tool from the KTC trim tool set to avoid damage when removing components.
1. Lower the grab handle (A), then insert a small flat-tip screwdriver wrapped in protective tape into the notch.
2. Use a KTC trim tool (A) to pull on the small flat-tip screwdriver, and remove the cap (B).
3. Pinch the clips (A) to release the hooks (B), then remove the grab handle (C).