RDX AWD L4-2.3L Turbo (2010)
10. Pull out the rear drain valve (A) from the body hole. Detach the clips (B), then pull down the drain tube (C) out of the pillar.
11. Install the frame and the drain tube in the reverse order of removal, and note these items:
-
Before installing the frame, clear the drain tubes and the drain valves using compressed air.
-
To install the front drain tube, tie a string left in the body during drain tube removal to the top end of the new drain tube and pull it up into the
roof.
-
Check the frame seal.
-
Clean the surface of the frame.
-
When installing the frame, first attach the rear hooks into the body holes.
-
Make sure each connector is plugged in properly.
-
When connecting the drain tube, slide them over the frame nozzle at least 10 mm (0.39 in).
-
Install the tube clip (A) on the drain tube (B) as shown.
-
After all parts are installed, including the headliner resetting the moonroof control unit See: Testing and Inspection/Programming and
Relearning.
-
Do the glass position adjustment procedure See: Adjustments.
12. Check for water leaks See: Doors, Hood and Trunk/Doors/Front Door/Front Door Window Glass/Adjustments. Let the water run freely from a
hose without a nozzle. Do not use a high-pressure spray.
