RDX AWD L4-2.3L Turbo (2010)
Seat Cover: Service and Repair
Front Seat Cushion Cover/Pad Replacement
Front Seat Cushion Cover/Pad Replacement
Special Tools Required
-
KTC Trim Tool Set SOJATP2014
*Available through the Acura Tool and Equipment Program; 888-424-6857
SRS components are located in this area. Review the SRS component locations See: Restraint Systems/Air Bag Systems/Locations and the precautions
and procedures See: Interior Moulding / Trim/Dashboard / Instrument Panel/Air Bag(s) Arming and Disarming/Service and Repair before doing repairs
or service.
NOTE:
-
Use the appropriate tool from the KTC trim tool set to avoid damage when removing components.
-
Take care not to tear or damage the seat covers.
-
Put on gloves to protect your hands.
1. Remove the front seat See: Service and Repair/Front Seat Removal/Installation.
2. Remove the screw and release the hooks (A) and the tab (B), then remove the front cover (C).
NOTE: The driver's seat is shown; the passenger's seat is similar.
3. Driver's seat: Remove the recline cover (A).
1. Remove the screw and detach the hooks (B).
2. Pull up the cover, then detach the hooks (C).
3. Disconnect the power seat adjustment switch connector (D), and the lumbar support switch connector (E).