RDX AWD L4-2.3L Turbo (2010)
Yaw Rate Sensor: Testing and Inspection
Yaw Rate-Lateral Acceleration Neutral Position Memorization
Whenever the yaw rate-lateral acceleration sensor is replaced, its neutral position memorization must be done.
1. With the ignition switch in LOCK (0), connect the HDS to the DLC (A) located under the driver's side of the dashboard.
2. Turn the ignition switch to ON (II).
3. Make sure the HDS communicates with the vehicle and the SH-AWD control unit. If it does not, go to the DLC circuit troubleshooting See:
Powertrain Management/Computers and Control Systems/Testing and Inspection/Component Tests and General Diagnostics/DLC Circuit
Troubleshooting.
4. From the mode menu, select MISCELLANEOUS TEST, then select NEUTRAL MENU with the HDS, and follow the screen prompts.
NOTE: See the HDS help menu for specific instructions.