RDX AWD L4-2.3L Turbo (2010)
14. Install the thermostat housing assembly (C) with a new O-ring (D) to the water passage.
15. Apply liquid gasket (P/N 08717-0004, 08718-0003, 08718-0004, or 08718-0009) to the engine block mating surface of the water passage and to
the inside edge of the threaded bolt holes. Install the component within 5 minutes of applying the liquid gasket.
NOTE:
-
Apply a 3 mm (0.12 in) diameter bead of liquid gasket along the broken line (A).
-
If you apply liquid gasket P/N 08718-0012, the component must be installed within 4 minutes.
-
If too much time has passed after applying the liquid gasket, remove the old liquid gasket and residue, then reapply new liquid gasket.
16. Install the water passage assembly (A) with a new O-ring (B).
NOTE:
-
Wait at least 30 minutes before filling the engine with coolant.
-
Do not run the engine for at least 3 hours after installing the water passage.