RDX AWD L4-2.3L Turbo (2010)
Rocker Arm Assembly: Overhaul
Rocker Arm and Shaft Disassembly/Reassembly
NOTE:
-
Identify parts as they are removed so they can be reinstalled in their original locations.
-
Inspect the rocker arm shaft and rocker arms See: Cylinder Head Assembly/Service and Repair/Overhaul/Rocker Arm and Shaft Inspection.
-
If reused, the rocker arms must be installed in their original locations.
-
When removing, or installing the rocker arm assembly, do not remove the camshaft holder bolts. The bolts will keep the holders and rocker arms
on the shaft.
-
Bundle the rocker arms with rubber bands to keep them together as a set, and remove the bands after the rocker arms have been installed.
-
Prior to reassembling, clean all the parts in solvent, dry them, and apply new engine oil to all the contact points.
-
When replacing the intake rocker arm assembly, remove the fastening hardware from the new intake rocker arm assembly.