RDX AWD L4-2.3L Turbo (2010)
5. Remove the bolts from the rocker shaft holder.
6. Make sure the punch marks on the VTC actuator and the exhaust camshaft sprocket are facing up, then set the camshafts (A) in the holder. Apply
new engine oil to the camshaft journals and lobs.
7. Set the camshaft holders (B) and cam chain guide B (C) in place.
8. Tighten the bolts to the specified torque.
NOTE: If the engine does not have bolt 21, 22, 23, skip it and continue the torque sequence.
