RDX AWD L4-2.3L Turbo (2010)
2. Install the crankshaft pulley, and tighten the bolt. Do not use an impact wrench.
1. Hold the pulley with the holder handle (A) and the holder attachment (B). Tighten the bolt to 49 Nm (5.0 kg-m, 36 lb-ft) with a torque wrench
and a 19 mm socket (C). Tighten the bolt to 49 Nm (5.0 kg-m, 36 lb-ft) with a torque wrench and 19 mm socket (C). Do not use an impact
wrench. If you are using a new pulley bolt or new crankshaft, tighten the bolt to 177 Nm 130 lb-ft) with a torque wrench and socket, loosen the
bolt and tighten it 49 Nm (5.0 kg-m, 36 lb-ft).
2. Mark the bolt head (D) and the crankshaft pulley (E) as shown, then tighten the bolt an additional 90 ° (The mark on the bolt head lines up
with the mark on the crankshaft pulley).
3. Install the drive belt See: Drive Belts, Mounts, Brackets and Accessories/Drive Belt/Service and Repair.
4. Install the splash shield See: Body and Frame/Splash Guard/Service and Repair/Front Splash Shield Replacement.
5. Install the front wheels.
