RDX AWD L4-2.3L Turbo (2010)
9. Remove the No. 2 and No. 3 camshaft holder bolts, and install the VTEC air adapters (C) finger-tight.
10. Connect the air joint adapter (D) and air pressure regulator (E).
11. Loosen the valve on the air pressure regulator, and apply the specified air pressure.
NOTE: If the rocker arm piston does not move after applying air pressure; move the primary or secondary rocker arm up and down manually by rotating
the crankshaft clockwise.
12. With the specified air pressure applied, move the intake primary rocker arm (A) for the No. 1 cylinder. The primary rocker arm and secondary
rocker arm (B) should move together.
If the intake secondary rocker arm does not move, remove the primary and secondary rocker arms as an assembly, and check that the pistons in the
primary and secondary rocker arms move smoothly. If any rocker arm needs replacing, replace the primary and secondary rocker arms as an assembly,
and test.
13. Remove the air pressure regulator, the air joint adapter, the VTEC air adapters, and the VTEC air stopper.
14. Tighten the camshaft holder mounting bolts to 22 Nm (2.2 kg-m, 16 lb-ft).
