RDX AWD L4-2.3L Turbo (2010)
10. Connect the engine wire harness connectors, and install the wire harness clamps to the intake manifold.
-
Four injector connectors
-
Throttle body connector
-
MAP sensor connector
-
IAT sensor connector
-
Turbocharger bypass control solenoid valve connector
11. Install the injector cover.
12. Install the charge air cooler See: Powertrain Management/Fuel Delivery and Air Induction/Turbocharger/Intercooler/Service and Repair.
13. After installation, check that all tubes, hoses, and connectors are installed correctly.
14. Clean up any spilled engine coolant.
15. Inspect for fuel leaks: Turn the ignition switch to ON (II) (do not operate the starter) so the fuel pump runs for about 2 seconds and pressurizes the
fuel line. Repeat this operation two or three times, then check for fuel leakage at any point in the fuel line.
16. Refill the radiator with engine coolant, and bleed the air from the cooling system with the heater valve open See: Cooling System/Coolant/Service
and Repair.