RDX AWD L4-2.3L Turbo (2010)
Air Door Actuator / Motor: Service and Repair
Mode Control Motor Replacement
Mode Control Motor Replacement
1. Remove the glove box See: Body and Frame/Interior Moulding / Trim/Glove Compartment/Service and Repair/Glove Box Removal/Installation.
2. Remove the climate control unit See: Control Assembly/Service and Repair/Climate Control Unit Removal/Installation.
3. Remove the harness clip (A), the self-tapping screws and the passenger's heater duct (B).
4. Disconnect the 7P connector (A) from the mode control motor (B). Remove the self-tapping screws and the mode control motor from the heater
unit.
5. Install the motor in the reverse order of removal. Make sure the pin on the motor is properly engaged with the linkage. After installation, make
sure the motor runs smoothly.