RDX AWD L4-2.3L Turbo (2010)
Fuel Gauge Sender: Service and Repair
Fuel Tank Unit Removal/Installation
Fuel Tank Unit Removal and Installation
Special Tools Required
-
Fuel Sender Wrench 07AAA-S0XA100
Removal
1. Relieve the fuel pressure See: Engine, Cooling and Exhaust/Engine/Cylinder Head Assembly/Fuel Pressure Release/Service and Repair.
2. Remove the fuel fill cap.
3. Fold the rear seat down, then remove the left rear door sill trim See: Body and Frame/Interior Moulding / Trim/Scuff Plate/Service and Repair.
4. Pull back the carpet to expose the access panel See: Body and Frame/Interior Moulding / Trim/Carpet/Service and Repair.
5. Remove the access panel (A) from the left side of the floor.
6. Disconnect the fuel tank unit 4P connector (B).
7. Disconnect the quick-connect fittings (C) from the fuel tank unit.
8. Using the special tool, loosen the locknut (A).