RDX AWD L4-2.3L Turbo (2010)
Headlamp Bulb: Service and Repair
HID Bulb Replacement
HID Bulb Replacement
WARNING
A transient high tension (25,000 V) occurs at the bulb sockets of the high intensity discharge (HID) lamps when the combination light switch is
turned ON, that may cause serious electrical shock or electrocution if you do not observe the cautions.
CAUTION
-
Never turn on the combination light switch before fitting the HID bulbs to their bulb sockets and completing the reassembly of the
headlight assembly.
-
Do not service the headlights assembly in wet conditions, such as rain or snow, near a sprinkler system, or when your hands are wet to
prevent electrocution.
-
Do not touch the surface of the HID bulbs with your bare hands and do not stain it with any oils and fats.
-
Do not disassemble the inverter unit and the igniter unit.
-
Do not turn on the HID bulb by using a power source other than the battery mounted on the vehicle.
1. Do the battery terminal disconnection procedure See: Starting and Charging/Battery/Service and Repair/Procedures.
2. Turn the combination light switch OFF.
3. Remove the headlight assembly See: Service and Repair/Headlight Replacement.
4. Turn the cover (A) 45 ° counterclockwise to remove it from the headlight assembly.
5. Turn the socket (A) 45 ° counterclockwise to remove it from the bulb (B) and remove the 1P connector (C).
