RDX AWD L4-2.3L Turbo (2010)
20. Pull on the string, and push the harness in to guide it through the headlight housing. If the harness gets caught, use your fingers to guide the harness
as high and as close to the lens as possible. Make sure the harness is routed over the bracket as shown.
21. Remove the tape from the wire terminals and the terminal boot, then insert the wire terminals into their correct cavities in the 4P connector housing.
22. Reinstall the headlight, the front turn signal/front parking light, and the front side marker light into the headlight housing.
23. Reinstall the corner upper beam on the headlight housing.
24. Reinstall the headlight housing.
25. Reconnect all the connectors.
26. Reinstall the bumper:
^
Reconnect the fog light connectors.
^
Make sure the front bumper engages the hooks of both corner upper beams and the side spacers (on each side) securely.
^
Reinstall all the clips, the screws, and the bolts.
^
Replace any damaged clips.
27. Adjust the headlights.
Disclaimer
