RDX AWD L4-2.3L Turbo (2010)
5. If the indicated maintenance is not done, the "SERVICE PAST DUE" message shows a negative distance traveled, for example "-10 miles," on the
display. If the negative distance traveled is between 0 and -9, the message is displayed for only a few seconds when the ignition switch is turned to
ON (II). The negative distance traveled (A) remains displayed after the vehicle is driven more than 10 miles (for USA models) or 10 km (for
Canada models) after 0 % oil life is reached, and the display cannot be canceled. This means the indicated maintenance item(s) should have been
done more than 10 miles (or 10 km) ago.
Resetting the Maintenance Minder
NOTE:
-
The vehicle must be stopped to reset the Maintenance Minder.
-
If a required service is done and the Maintenance Minder is not reset, or if the Maintenance Minder is reset without doing the service, the system
will not show the proper maintenance timing. This can lead to serious mechanical problems because there will be no accurate record of when the
required maintenance is needed.
-
The engine oil life and the maintenance item(s) can be independently reset with the HDS.
1. Turn the ignition switch to ON (II).
2. If system message(s) are displayed, press the INFO button to cancel the display.
3. Push and release the SEL/RESET button repeatedly until the engine oil life indicator is displayed.
4. Press and hold the SEL/RESET button for about 10 seconds, the "OIL LIFE RESET" mode display appears.
NOTE:
-
If you are resetting the Maintenance Minder when the engine oil life is more than 15 %, make sure any maintenance item(s) requiring service
are done before resetting the display.
-
To cancel the "OIL LIFE RESET" mode, press the INFO button repeatedly until the "CANCEL" indicator displayed, then press the
SEL/RESET button.
5. Press the INFO button repeatedly until the "RESET" indicator is displayed, then press the SEL/RESET button.
The maintenance item code(s) will disappear, and the engine oil life will reset to"100 %."
