RDX AWD L4-2.3L Turbo (2010)
Fuse Block: Service and Repair
Under-Dash Fuse/Relay Box Removal/Installation
Under-Dash Fuse/Relay Box Removal and Installation
Special Tools Required
-
Relay Puller 07AAC-000A2A1 or 07AAC-000A1A0
SRS components are located in this area. Review the SRS component locations See: Restraint Systems/Air Bag Systems/Locations and precautions and
procedures See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Air Bag(s) Arming and Disarming/Service and Repair before
doing or servicing.
Removal
1. Do the battery terminal disconnection procedure See: Starting and Charging/Battery/Service and Repair/Procedures.
2. Remove the driver's dashboard undercover See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Service and
Repair/Driver's Dashboard Undercover Removal/Installation.
3. Disconnect the connectors from the fuse side of the under-dash fuse/relay box (A).
4. Remove the mounting bolts, and pull the fuse/relay box away from the body.
5. Disconnect the connectors from the back side of the under-dash fuse/relay box, then remove the under-dash fuse/relay box.
6. Carefully remove the relays by using the relay puller.
NOTE: Do not use pliers. Pliers will damage the relays, which could cause the engine to stall or not start.
Installation
1. Install the relays and connect the connectors to the under-dash fuse/relay box, then install the under-dash fuse/relay box in the reverse order of
removal.
2. Install the removed parts in the reverse order of removal.
3. Do the battery terminal reconnection procedure See: Starting and Charging/Battery/Service and Repair/Procedures.
4. Register the immobilizer system with the HDS See: Accessories and Optional Equipment/Antitheft and Alarm Systems/Testing and
Inspection/Programming and Relearning.