RDX AWD L4-2.3L Turbo (2010)
13. Remove the spring clip (B) and control pin (C), then separate the shift cable end (D) from the control lever (E).
14. Check the bushing (F) in the shift cable end for proper fit and wear. If the bushing is loose or worn, replace the shift cable See: Transmission and
Drivetrain/Automatic Transmission/Transaxle/Shift Linkage/Shift Cable/Service and Repair.
15. Disconnect the input shaft (mainshaft) speed sensor connector (A), the output shaft (countershaft) speed sensor connector (B), the transmission
fluid pressure switch B (3rd clutch) connector (C), and the ATF temperature sensor connector (D).
16. Disconnect the A/T clutch pressure control solenoid valve A connector (A), the solenoid valve B connector (B), and the shift solenoid harness
connector (C).