RDX AWD L4-2.3L Turbo (2010)
21. Disconnect one of the jumper wires, and check valve movement at the fluid passage in the valve body mounting surface. If the valve binds or
moves sluggishly, or if the solenoid valve does not operate, replace A/T clutch pressure control solenoid valves A and B.
22. Clean the mounting surface and fluid passage of the solenoid valve body and solenoid valve cover.
23. Install a new solenoid valve body gasket on the solenoid valve cover, and install the ATF pipes with the filter end in the transmission housing.
Install new O-rings over the ATF pipes.
24. Install A/T clutch pressure control solenoid valves A and B.
25. Secure the harness cover with the bolt.
26. Check the connectors for rust, dirt, or oil, and clean or repair if necessary, then connect the connectors securely.
27. Apply molybdenum grease to the hole in the bushing in the shift cable end. Attach the shift cable end to the selector control lever, then insert the
control pin into the selector control lever hole through the shift cable end, and secure the control pin with the spring clip.
28. Secure the shift cable bracket with the nuts.
29. Install the battery base See: Engine, Cooling and Exhaust/Engine/Service and Repair/Engine Installation.
30. Install the air cleaner See: Fuel Delivery and Air Induction/Air Cleaner Housing/Service and Repair.
31. Install the charge air cooler cover See: Fuel Delivery and Air Induction/Turbocharger/Intercooler/Service and Repair.
32. Do the battery installation procedure See: Starting and Charging/Battery/Service and Repair/Removal and Replacement.