RDX AWD L4-2.3L Turbo (2010)
Shift Interlock Solenoid: Testing and Inspection
Shift Solenoid Valve Test, Replacement, and Shift Solenoid Wire Harness Replacement
Shift Solenoid Valve Test, Replacement, and Shift Solenoid Wire Harness Replacement
1. Connect the HDS to the DLC (A).
2. Turn the ignition switch to ON (II). Make sure the HDS communicates with the PCM. If it does not, go to the DLC circuit troubleshooting See:
Computers and Control Systems/Testing and Inspection/Component Tests and General Diagnostics/DLC Circuit Troubleshooting.
3. Select Shift Solenoid valve A, B, C, or D in the Miscellaneous Test Menu with the HDS.
4. Check that shift solenoid valves A, B, C, or D operate with the HDS. A clicking sound should be heard.
-
If a clicking sound is heard, the valves are OK. The test is complete, disconnect the HDS.
-
If no clicking sound is heard, go to step 5, and test the solenoid valves.
5. Do the battery removal procedure See: Starting and Charging/Battery/Service and Repair/Removal and Replacement.
6. Remove the air cleaner See: Fuel Delivery and Air Induction/Air Cleaner Housing/Service and Repair.
7. Remove the battery base See: Engine, Cooling and Exhaust/Engine/Service and Repair/Engine Removal.
8. Remove the spring clip (A) and the control pin (B), then separate the shift cable end (C) from the selector control lever (D).
