RDX AWD L4-2.3L Turbo (2010)
Fluid Pressure Sensor/Switch: Service and Repair
Transmission Fluid Pressure Switch B (3rd Clutch) Replacement
Transmission Fluid Pressure Switch B (3rd Clutch) Replacement
1. Raise the vehicle on a lift, or apply the parking brake, block the rear wheels, and raise the front of the vehicle. Make sure it is securely supported.
2. Remove the splash shield See: Body and Frame/Splash Guard/Service and Repair/Front Splash Shield Replacement.
3. Disconnect the transmission fluid pressure switch B (3rd clutch) connector, and remove the switch (B).
4. Install a new transmission fluid pressure switch B (3rd clutch) and a new sealing washer (A), and tighten the switch.
5. Check the connector for rust, dirt, or oil, and clean or repair if necessary, then connect the connector securely.
6. Install the splash shield See: Body and Frame/Splash Guard/Service and Repair/Front Splash Shield Replacement.
