RDX AWD L4-2.3L Turbo (2010)
Transmission Position Switch/Sensor: Testing and Inspection
Transmission Range Switch Test
1. Do the battery removal procedure See: Starting and Charging/Battery/Service and Repair/Removal and Replacement.
2. Remove the battery base See: Engine, Cooling and Exhaust/Engine/Service and Repair/Engine Removal.
3. Disconnect the transmission range switch connector.
4. Check for continuity between terminals at the transmission range switch connector. There should be continuity between the terminals in the
following table for each switch position.
5. Transmission range switch test is finished if the test results are OK. If there is no continuity between any terminals, check that the transmission
range switch installation. If the switch installation is OK, replace the transmission range switch See: Service and Repair.
6. Check the connector for rust, dirt, or oil, and clean or repair if necessary, then connect the connector securely.
7. Install the battery base See: Engine, Cooling and Exhaust/Engine/Service and Repair/Engine Installation.
8. Do the battery installation procedure See: Starting and Charging/Battery/Service and Repair/Removal and Replacement.
