RDX AWD L4-2.3L Turbo (2010)
Control Unit: Testing and Inspection
SH-AWD Control Unit Initialization
SH-AWD Control Unit Initialization
Whenever the SH-AWD control unit is replaced, it must initialized.
1. With the ignition switch in LOCK (0), connect the HDS to the DLC (A) located under the driver's side of the dashboard.
2. Turn the ignition switch to ON (II).
3. Make sure the HDS communicates with the vehicle and the SH-AWD control unit. If it does not, go to the DLC circuit troubleshooting See:
Powertrain Management/Computers and Control Systems/Testing and Inspection/Component Tests and General Diagnostics/DLC Circuit
Troubleshooting.
4. From the mode menu, select MISCELLANEOUS TEST, then select INITIALIZATION with the HDS, and follow the screen prompts.
NOTE: See the HDS help menu for specific instructions.