RDX AWD L4-2.3L Turbo (2010)
Seat Belt: Service and Repair
Front Seat Belt Replacement
Front Seat Belt Replacement
SRS components are located in this area. Review the SRS component locations See: Air Bag Systems/Locations and the precautions and procedures
See: Air Bag(s) Arming and Disarming/Service and Repair before doing repairs or service.
NOTE:
-
Check the front seat belts for damage See: Testing and Inspection, and replace them if necessary.
-
If replacing the front seat belts after deployment, refer to Component Replacement/Inspection After Deployment See: Air Bag Systems/Service
and Repair for a complete list of other parts that must also be replaced.
-
Use the appropriate tool from the KTC trim tool set to avoid damage when removing components.
Front Seat Belt
1. Slide the front seat forward fully.
2. Do the battery terminal disconnection procedure See: Starting and Charging/Battery/Service and Repair/Procedures,then wait at least 3 minutes
before beginning work.
3. Carefully pry up on the bottom of the anchor cover (A) at the pry point (B) with the appropriate trim tool to release the hooks (C) and the tab (D),
then remove the cover by pulling it upward.