RDX AWD L4-2.3L Turbo (2010)
11. Remove the B-pillar lower trim See: Body and Frame/Interior Moulding / Trim/Trim Panel/Service and Repair/Pillar Trim/Interior Trim
Removal/Installation - Pillar Areas.
12. Disconnect the SRS wire harness 4P connector (A) from the driver's and the front passenger's seat belt tensioner. Pull the seat belt out all the way
and cut it.
Seat Belt Buckle Tensioner
13. Disconnect the SRS wire harness 4P connector (A) from the driver's and the front passenger's seat belt buckle tensioner.
14. Cut off each connector, and strip the ends of the wires. Twist each pair of unlike colored wires together, and clip an alligator clips (A) from the
deployment tool to each pair.
NOTE:
-
Place the deployment tool at least 30 ft (10 m) away from the vehicle.
-
The driver's and front passenger's airbags have dual inflators. Twist each pair of unlike colored wires together, and clip an alligator clip to each
pair.