RDX AWD L4-2.3L Turbo (2010)
Impact Sensor: Service and Repair
Side Impact Sensor (Second) Replacement
Side Impact Sensor (Second) Replacement
Removal
1. Do the battery terminal disconnection procedure See: Starting and Charging/Battery/Service and Repair/Procedures, then wait for 3 minutes
before starting work.
2. Remove the rear seat and seat side bolster See: Body and Frame/Seats/Service and Repair/Rear Seat Removal/Installation.
3. Disconnect the SRS wire harness 2P connector (A) from the side impact sensor (second).
4. Remove the TORX bolt (B) using a TORX T30 bit, then remove the side impact sensor (second) (C).
Installation
1. Install the side impact sensor (second) (A) with a new TORX bolt (B) using a TORX T30 bit, then connect SRS wire harness 2P connector (C) to
the side impact sensor (second).
2. Do the battery terminal reconnection procedure See: Starting and Charging/Battery/Service and Repair/Procedures.
3. Clear any DTCs with the HDS See: Air Bag Systems/Testing and Inspection/Reading and Clearing Diagnostic Trouble Codes.
4. Confirm proper SRS operation: Turn the ignition switch to ON (II), and check that the SRS indicator comes on for about 6 seconds and then go
off.