RDX 2010 Seat Position Sensor Component Locations - Page 4706
Seat Position Sensor: Service and Repair
Driver's Seat Position Sensor Replacement
Removal
NOTE:
-
Removal of the driver's seat position sensor must be done according to Precautions and Procedures See: Air Bag Systems/Air Bag(s) Arming and
Disarming/Service and Repair.
-
Do not turn the ignition switch to ON (II), and do not connect the battery cable while removing the driver's seat position sensor.
1. Raise the driver's seat all the way up.
2. Do the battery terminal disconnection procedure See: Starting and Charging/Battery/Service and Repair/Procedures, then wait at least 3 minutes
before starting work.
3. Remove the upper rail inner cover See: Body and Frame/Seats/Service and Repair/Front Seat Frame Replacement - Driver's Seat.
4. Disconnect the driver's seat wire harness 2P connector (A) from the driver's seat position sensor (B).
5. Remove the TORX bolt (C) using a TORX T30 bit and nut (D), then remove the driver's seat position sensor.
Installation
NOTE:
-
Be sure to install the harness so it does not pinched or interferes with other parts.
-
Do not turn the ignition switch to ON (II) and do not connect the battery cable while installing the driver's seat position sensor.
1. Install the driver's seat position sensor with a new TORX bolts (A) and new nut (B).
