RDX AWD L4-2.3L Turbo (2010)
Braking Sensor/Switch: Adjustments
Brake Pedal and Brake Pedal Position Switch Adjustment
Pedal Height
1. Remove the driver's dashboard undercover See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Service and
Repair/Driver's Dashboard Undercover Removal/Installation.
2. Turn the brake pedal position switch 45 ° counterclockwise, and pull it back until it is no longer touching the brake pedal.
3. Remove the driver's side kick panel See: Body and Frame/Interior Moulding / Trim/Scuff Plate/Service and Repair.
4. Remove the footrest See: Body and Frame/Interior Moulding / Trim/Carpet/Service and Repair.
5. Remove the steering joint cover.
6. Pull back the carpet, and find the cutout (A) in the insulation. Measure the pedal height (B) from the left side middle of the brake pedal pad (C) to
the floor (D) without the insulation as shown.
7. Loosen the pushrod locknut (A), and screw the pushrod (B) in or out with pliers until the standard pedal height from the floor is reached. After
adjustment, tighten the locknut firmly. Do not adjust the pedal height with the pushrod pressed.
