RDX AWD L4-2.3L Turbo (2010)
Fuel Gauge Sender: Service and Repair
Secondary Fuel Gauge Sending Unit Removal/Installation
Secondary Fuel Gauge Sending Unit Removal/Installation
Special Tools Required
-
Fuel Sender Wrench 07AAA-S0XA100
Removal
1. Relieve the fuel pressure See: Engine, Cooling and Exhaust/Engine/Cylinder Head Assembly/Fuel Pressure Release/Service and Repair.
2. Remove the fuel fill cap.
3. Fold the rear seat down, then remove the right rear door sill trim See: Body and Frame/Interior Moulding / Trim/Scuff Plate/Service and Repair.
4. Pull back the carpet to expose the access panel See: Body and Frame/Interior Moulding / Trim/Carpet/Service and Repair.
5. Remove the access panel (A) from the right side of the floor.
6. Disconnect the secondary fuel gauge sending unit 4P connector (B).
7. Using the special tool, loosen the locknut (A).
8. Remove the locknut (A), and lift up the secondary fuel gauge sending unit (B) from the fuel tank. Then disconnect the transfer tube (C).