RDX AWD L4-2.3L Turbo (2010)
Impact Sensor: Service and Repair
Front Impact Sensor Replacement
Front Impact Sensor Replacement
Removal
1. Do the battery terminal disconnection procedure See: Starting and Charging/Battery/Service and Repair/Procedures, then wait for 3 minutes
before starting work.
2. Remove the front bumper See: Body and Frame/Bumper/Front Bumper/Service and Repair.
3. Disconnect the engine compartment wire harness 2P connector (A) from the front impact sensor.
4. Remove the TORX bolts (B) using a TORX T30 bit, then remove the front impact sensor (C).
Installation
1. Install the front impact sensor (A) with new TORX bolts (B) using a TORX T30 bit, then connect the engine compartment wire harness 2P
connector (C) to the front impact sensor.
2. Do the battery terminal reconnection procedure See: Starting and Charging/Battery/Service and Repair/Procedures.
3. Clear any DTCs with the HDS See: Restraint Systems/Air Bag Systems/Testing and Inspection/Reading and Clearing Diagnostic Trouble Codes.
4. Confirm proper SRS operation: Turn the ignition switch to ON (II), and check that the SRS indicator comes on for about 6 seconds and then go
off.