RDX AWD L4-2.3L Turbo (2010)
Starter Motor: Testing and Inspection
Starter Performance Test
1. Remove the starter See: Service and Repair/Removal and Replacement.
2. Clamp the starter firmly in a vise.
3. Make the connection for this test using the thickest (gauge) wire possible (preferably the same gauge as used on the vehicle).
NOTE: To avoid damaging the starter, never leave the battery connected for more than 5 seconds.
4. Connect the battery as shown, and check for continuity between the B terminal and the starter body. If there is continuity, it is working properly.
5. Disconnect the battery from the body, and check for continuity between the B terminal and the starter body. If there is no continuity, it is working
properly.
6. Connect the starter to the battery as shown, and confirm that the motor turns.