RDX AWD L4-2.3L Turbo (2010)
3. Connect a hose (B) of suitable diameter to the disconnected return hose, and put the hose end in a suitable container.
4. Start the engine, let it run at idle, and turn the steering wheel from lock to lock several times. When fluid stops running out of the hose, shut off the
engine. Discard the fluid.
NOTE: Stop the engine immediately once the fluid stops running out of the hose to prevent pump damage.
5. Reinstall the return hose on the reservoir.
6. Fill the reservoir to the upper level line (C).
7. Start the engine, and run it at idle. Turn the steering from lock to lock several times to bleed air from the system.
8. Recheck the fluid level, and add some if necessary. Do not fill the reservoir beyond the upper level line.
9. If the fluid is contaminated, dark, or discolored, repeat the procedure as necessary until the system is clean.
