RDX AWD L4-2.3L Turbo (2010)
Steering Gear Mount: Service and Repair
Steering Gearbox Mount Cushion Replacement
1. Remove the steering gearbox See: Service and Repair/Removal and Replacement/Steering Gearbox Removal.
2. Position a 34 mm socket (A) on the flange part of the gearbox housing with a washer (B), a 10 x 105 mm flange bolt (C) and a 10 mm nut (D) as
shown.
3. Hold the flange bolt with a wrench, and tighten the nut with a wrench. Remove the gearbox mount cushion (E).
4. Apply a mild soap and water solution to the new gearbox mount cushion surface (A), then place it on the gearbox mounting cushion hole.
5. Position a 34 mm socket on the flange part of the gearbox housing with a washer, a flange bolt, and a nut as shown.
6. Install the gearbox mount cushion by tightening the flange bolt until the mount cushion edges (B) properly fits on the gearbox flange surface.
7. Install the steering gearbox See: Service and Repair/Removal and Replacement/Steering Gearbox Installation.
