RDX AWD L4-2.3L Turbo (2010)
-
Always use a new valve stem grommet whenever the tire pressure sensor has been removed from the wheel. When only removing a tire from
the wheel, replace the valve stem grommet if it is possible.
Installation
NOTE: Use only wheels that have a "TPMS" stamp (A) on them.
1. Before installing the tire pressure sensor, clean the mating surfaces on the sensor and the wheel.
2. Install the tire pressure sensor (A) and the washer (B) to the wheel (C), and tighten the valve stem nut (D) finger tight. Make sure the pressure
sensor is resting on the wheel.
NOTE: Install the tire pressure sensor so that the sensor housing surface (E) should not exceed the protrusion (F) of the wheel to prevent the sensor
housing from being caught on the bead of the tire when assembling the tire. Be sure to always mount the tire pressure sensor with the feet (G) in the
downward position toward the wheel.
