RDX AWD L4-2.3L Turbo (2010)
11. Clean the mounting surfaces and the fluid passage of the solenoid valve cover.
12. Install a new solenoid valve body gasket on the solenoid valve cover, and install the ATF pipes with the filter end in the transmission housing.
Install new O-rings over the ATF pipes.
13. Install A/T clutch pressure control solenoid valves A and B.
14. Secure the harness cover with the bolt.
15. Check the connectors for rust, dirt, or oil, and clean or repair if necessary, then connect the connectors securely.
16. Apply molybdenum grease to the hole in the bushing in the shift cable end, then install the shift cable bracket with the nuts.
17. Attach the shift cable end to the selector control lever, then insert the control pin into the selector control lever hole through the shift cable end,
and secure the control pin with the spring clip.
18. Install the battery base See: Engine, Cooling and Exhaust/Engine/Service and Repair/Engine Installation.
19. Install the air cleaner See: Engine, Cooling and Exhaust/Engine/Tune-up and Engine Performance Checks/Air Cleaner Housing/Service and Repair
.
20. Do the battery installation procedure See: Starting and Charging/Battery/Service and Repair/Removal and Replacement.
