RDX AWD L4-2.3L Turbo (2010)
Shift Solenoid: Service and Repair
Shift Solenoid Valve Removal and Installation
NOTE:
-
Do not hold the shift solenoid valve connector to remove and install the shift solenoid valve. Be sure to hold the shift solenoid valve body.
-
Do not install shift solenoid valve C before installing shift solenoid valve A. If shift solenoid valve C is installed before installing shift solenoid
valve A, it may damage to hydraulic control system.
1. Remove the shift solenoid valve mounting bolts, then remove the shift solenoid valves by holding the shift solenoid valve body.
2. Install new O-rings (two O-rings per shaft solenoid valve) (E) on each shift solenoid valves.
NOTE: If you are installing a new shift solenoid valve, it comes with new O-rings already installed.
3. Install shift solenoid valve D (black connector) by holding the shift solenoid valve body; be sure the mounting bracket contacts the accumulator
body.
4. Install shift solenoid valve A (black connector) by holding the shift solenoid valve body; be sure the mounting bracket contacts the accumulator
body.
5. Install shift solenoid valve C (brown connector) by holding the shift solenoid valve body; be sure to position the mounting bracket on top of the
bracket of shift solenoid valve A.
6. Install shift solenoid valve B (brown connector) by holding the shift solenoid valve body; be sure the mounting bracket contacts the accumulator
body.
7. Install the shift solenoid valve mounting bolts.